TRL1/140-5.5 H Emulsifier /in line homogeniser

This is a brand new fully stainless steel toothed colloid mill/emulsifier.

It has a high shear dispersing action and is used for the continuous production or closed circuit treatment of fine material.

Typical products to be emulsified, might include: Mayonnaises, sauces, emulsions, lotions, creams, purees etc

Capacity: Max 5 Cub M/Hr (Water - conditions may vary)
Pump suction pressure is less than 0.2Mpa

STATOR DIMENSIONS
Inner Diameter: 120mm
Outer Diameter: 155mm
Gap between teeth (Inner) 4mm
Gap between teeth (Outer) 4mm

Tooth width(Inner) 8mm
Tooth width: Thickness(Outer) 11mm

ROTOR DIMENSIONS
inner Diameter: 95mm
Outer Diameter: 135mm
Gap between teeth (Inner) 4mm
Gap between teeth (Outer) 4m
Tooth width(Inner) 9mm
Tooth width Thickness(Outer) 14mm

This unit is fully stainless steel constructed and is fitted with 35mm "Triclover" type inlet and outlet ports, in addition to a drain port terminating with a manually operated butterfly valve at the base of the head.


Max discharge pressure is 0.2 MPA.
Drive Source - 5.5KW, 2920, 415V AC, Three Phase, TEFC Electric Motor direct coupled to the head.